Caretaking Support Services offer PAT Testing services in The High Peak

Portable Appliance Testing (also known as PAT Testing) is a way of checking your electrical equipment to see if it is SAFE.

We provide PAT Testing services to a wide range of High peak businesses including Offices, Garages, Workshops, Nursing Homes, Schools, Hotels, Bed and Breakfasts, Caravans, Commercial Kitchens and Construction Sites to name but a few.

Health And Safety - Did you know?

Failure to have your appliances tested can result in a criminal offence under the consumer protection act 1987; this can carry a fine of £5,000 and or a 6 months imprisonment.

We test all portable appliances

Some examples include Business Equipment, Desktop Computers, Electric Fans, Electric Heaters, Extension Leads, Fridges, Freezers, Toasters, Hair Dryers, Hand-held Equipment, Heating Appliances, IEC Cables, IT Equipment, Kettles, LCD Screens, Lamps, Laptops, Mains Extensions, Microwaves, Monitors, Power Cords, Power tools, Surge Protected Appliances, Televisions and many more.

What we do

Our high spec PAT Testing Kit enables us to test a wider range of appliances than some of our competition in the High Peak. This includes testing of 110V Appliances and extensions, IT Equipment at 200mA for earth Bond tests as well as a large amount of Pat Testing Adapters for different IT Equipment. Our tests include a signed Certificate and Report on all appliances tested for Class 1 and Class 2 Appliances. Our tests include earth continuity test, insulation test, electrical wiring inspection, leakage tests including a special microwave leakage test, electrical installation earthing, formal visual inspection, functional test, insulation resistance, cable damage, cable resistances, fuse check, wiring plugs.

Portable Appliance Testing is a very necessary part of your organisation's Health and Safety regime. It doesn't matter whether you're a sole trader or a large multi-national corporation; if you use electrical equipment in your business, then you have a responsibility to make sure it is safe.

Moreover, Insurance companies are now insisting on PAT Testing being carried out every 12 months (or less) in order to satisfy the conditions of their policy, and local council inspectors (Fire Officers, Environmental Health Officers) are routinely asking for evidence of PAT Testing when they carry out their inspections. HSE Maintaining portable electrical equipment HSG107 (Third edition) Published 2013

book now

  • PAT Testing Regulations
  • Videos
  • See Pricing Table
  • PAT Testing T&C's

Conforming to PAT testing regulations will help you to ensure that the portable appliances in your business are safe and help you to avoid violations. PAT testing legislation was put into effect to ensure that all companies conform to the Health and Safety at Work Act of 1974, Electricity at Work Regulations of 1989, Provision and Use of Work Equipment regulations of 1998 and the Management of Health and Safety at Work regulations of 1999.

The current law requires that all employers maintain portable appliances and ensure their safety. This is done through testing of the appliances to safeguard against damage and to make certain that these items perform properly.

PAT testing law requires that all landlords, employers and even self-employed individuals make sure that their portable electrical appliances are safe and are suitable and used for the purposes intended. These appliances should always be maintained properly and remain in good working order.

The guidelines are designed to make certain that this equipment is kept protected and is preserved through regular maintenance as well as inspections and periodic testing. Damage and fault can occur with all electrical equipment use which makes it essential that these items are tested regularly for safety.

PAT testing is done to ensure that all electrical equipment that is classified as “portable” is deemed safe for use. The legislation deems that any competent person can perform it by using a PAT instrument or tester. The visual examination of each appliance in addition to the actual PAT test should be performed only by someone who is deemed competent.

According to PAT testing legislation, a competent person is someone who has experience or knowledge of being able to check and test appliances for safety purposes. Those with knowledge of electricity in general as well as anyone who has experience in electrical work can be deemed capable.

It is imperative that employers, landlords and self-employed individuals follow the rules to ensure that their workplaces are safe. Testing can be done by any number of PAT testing companies.

Prices per Property

Number of Appliances

Price

Up to 10 £40.00
11 - 20 £50.00
21 - 30 £60.00
31 - 40 £70.00
41 - 50 £80.00
51 + Please contact me for a quote
Additional charges & tests
Microwave oven leakage test £3.50 inc PAT Test
Plug replacement
£1.50
Fuse replacement 35p
   
map
I cover the whole of the High Peak, including many areas within a 25 mile radius of Buxton including Macclesfield, Hazel Grove and Poynton.
Please Read PAT Testing Terms & Conditions>>

1) What do we get when you do PAT Testing for us?

If you engage my services, then virtually all* of the electrical equipment at your site that has either a standard 240 volt three-pin plug or a ' building site' 110 volt plug attached will be formally visually inspected and instrument-tested for safety. Each item will then be labelled with either a PASS label or, very occasionally!, a red FAIL label. PASS labels identify the PAT Testing Appliance ID (unique for each item inspected/tested by me at the site), the Pass Date, the Next Test Due date, and my contact details. Instead of the Pass Date, FAIL labels provide the Fail Date and display a clear warning that the item of equipment is not safe to use.

Any item of equipment that fails either the formal visual inspection or the instrument tests will be identified with a red FAIL label and brought to the attention of the Responsible Person, this typically being the person that deals with Health and Safety, otherwise a manager or similar. It is then the responsibility of that person to take appropriate measures to either have the item repaired, disposed of, or otherwise appropriately and safely dealt with. In the case of inexpensive, easily replaceable items such as computer/printer power leads, extension leads, table lamps, etc., the item is normally rendered unusable and disposed of there and then (with your agreement, of course); no, I don't go around chopping off plugs left, right and centre! It is true to say that, whilst I have no authority over your organisation, if you have in commission any unsafe item of electrical equipment whether you know it or not, then you are committing a serious criminal offence, not to mention the risk to people, animals or property.

If an item passes the combined formal visual inspection and instrument tests, but I have concern over some other aspect of its safety, for example, its suitability for the job for which it is being used, or perhaps the cables placed in a dangerous manner, then a PASS label will be applied, but the item will be brought to the attention of the Responsible Person to deal with in an appropriate and safe manner.

I always remove the covers of rewireable plugs to check for fuse rating, wire condition, etc. I carry a supply of new standard three-pin plugs and fuses, all BS/ASTA certified, so if an item of equipment under inspection/test needs either a new plug, the plug rewired or the fuse replaced for it to pass the tests, then this work will be carried out free of charge there and then (most contractors that carry out PAT Testing charge additional for this, typically £4 per item). I also carry a supply of new, standard IEC (computer) power cords. If one of these needs to be replaced, then this can be supplied at cost for just a couple of pounds (you may already have a few spares so one of these could be used instead; after testing it though, of course!). I do not undertake any other electrical repairs.

I will then send you an invoice for the work, payment of which is expected within 14 days. I will also contact you about eleven months later to discuss another visit.

On receipt of your payment,you will receive via Email, signed and dated copies of the Test Results and also the PAT Testing Certificate, along with a signed and dated covering-letter providing you with my business details, etc. in Adobe PDF, you may print all the documents but electronic storage is now an accepted practice & saves on paper.

In the event of a visit from the Health and Safety Executive, for example, you can produce these documents to provide evidence that you are taking positive steps to making sure that your electrical equipmentmeets the legal requirement of being, in simple terms, 'safe, well-maintained and suitable for the purpose for which it is being used'. I keep copies of these files on your behalf; if you ever lose your copy of any of the files, then I will of course supply you with replacements, free of charge.

2) Disclaimer/Limitation of Liability

When 'PA Testing', I adhere strictly to the Institute of Electrical Engineers (IEE) Code of Practice for In-service Inspection and Testing of Electrical Equipment.

Like most technicians and test engineers working in the field, my insurance cover is limited to damage to client's equipment and to Public Liability, etc. Therefore, it is taken that The Client understands and accepts the following terms and conditions before engaging my services, for Portable Appliance Testing.

When engaged in PA Testing, in no event shall Caretaking Support Services be liable for any losses whatsoever (including, without limitation, indirect, consequential, or incidental losses) to business profits, business interruption, loss of business information (including computer data or similar data), or other pecuniary loss arising out of the use of its services, even if Caretaking Support Services, have been advised of the possibility of such damages.

When PA Testing, systems such as file servers, mail servers, network switches/hubs and telecommunications equipment will not be inspected/tested without the express permission of The Client. Furthermore, it is assumed that important computer data/information has been backed up securely by The Client before inspection/testing commences.

When PAT Testing, equipment such as video recorders, clocks, central heating system timers, burglar alarms, etc. that lose their programmed memory when disconnected from mains voltage, will (for this reason) only be unplugged and inspected/tested by me with the express permission of the client, and it is the responsibility of the client to arrange for reprogramming of this equipment, if necessary.

3) Practical limitations

In the workplace, I test all items that have either a standard 240 volt three-pin plug or a ' building site' 110 volt plug attached. However, in rented property I only test the items (with plugs) that are supplied by the landlord. Similarly, in residential care homes, etc., I test all items (with plugs) that are supplied by the care-home owner either for use by the residents or by the staff. This is because personal equipment owned by tenants or residents is not covered by legislation, and is therefore not tested.

Systems such as file servers, mail servers, network switches/hubs and telecommunications equipment will not be inspected/tested by me without the express permission of the client.

I do not unplug and test telephony equipment such as PABX or ISDN boxes, etc. that are supplied by the telephone company (much of this equipment, once installed, should really never be unplugged).

Equipment such as video recorders, clocks, central heating system timers, burglar alarms, etc. that lose their programmed memory when disconnected from mains voltage, will (for this reason) only be unplugged and inspected/tested by me with the express permission of the client, and it is the responsibility of the client to arrange for reprogramming of this equipment, if necessary.

Please make sure that the equipment that you want inspected/tested is on site when I arrive! This is particularly pertinent in the case of laptop computer chargers, projectors, power tools, mobile phone chargers, etc. NB. In the case of equipment that is powered by a rechargeable battery, such as battery hand-held power tools, mobile phones, laptop computers, etc., you only need to supply me with the charger; I do not need access to the equipment itself.

The equipment can only be tested if I have easy access to its plug. If the plug is inaccessible, for example, hidden behind heavy, awkward objects, then unfortunately the equipment will not be tested. Furthermore, I can only test items that have either a standard 240 volt three-pin plug or a 'building site' 110 volt plug attached; electric cookers, water heaters, large built-in radiators, electric heaters, etc. that are directly wired into a fused outlet cannot be tested as this would necessitate the switching off of the electricity at the mains (something which would inconvenience everyone) and also the dismantling of the fused outlet, something which, like most PA Testers, I am not qualified, insured or legally allowed to do.

PAT testing information from UK PAT Testing Directory